A set of three replaceable ceramic D-pod cartridges, fully compatible with the INNUBIO InnoVape device. Each 1ml cartridge contains a guaranteed amount of 40% CBD and the full spectrum of natural cannabinoids, flavonoids and terpenoids.
Vaporisation, i.e. the pulmonary method, is one of the most effective methods of delivering cannabinoids, flavonoids and terpenoids to our body. It is characterized by high bioavailability – much higher than when using popular CBD oils or pastes with hemp extract. The accompanying phenomenon of vaporization is heating and evaporation, not burning, as is the case with standard smoking. The hot air stream therefore releases only active compounds, and the steam is devoid of any tar substances.
By choosing InnoVape, you get an all-natural product that is a combination of MCT oil and the highest purity hemp distillate, containing Futura 75 hemp extract, with a full spectrum of natural cannabinoids, flavonoids and terpenoids.
Cannabinoids delivered to the body by vaporisation start working within minutes of taking them. The bioavailability of the active compounds taken in this way is very high and estimated at about 60%. The effects of taking cannabinoids pulmonary can last up to 4 hours.
Taking care of the full safety of users, the mouthpiece and the D-pod cartridge coil are made of ceramics. Unlike most cartridges available on the market, the materials from which the InnoVape cartridge was made do not contain lead or other heavy metals.
It does not contain glycol and glycerine.
MCT oil, CBD distillate.
Remember! Vaporise responsibly.
Begin with a maximum of a few breaths a day and observe your bodys response.
If necessary, gradually increase the frequency.
During the vaporization you will feel the unique taste and aroma characteristic of the cannabis plants.
1 cartridge (1 ml) contains: 400 mg of CBD
3 cartridges (3 ml) contain: 1200 mg of CBD
Attach the battery cartridge to the battery by carefully screwing it in.
Start the device by pressing the button 5 times (the control diode will light up).
Hold the button and start vaporising.
After you finish using the device, turn the device off by pressing the button 5 times.
If the device is turned on, pressing the button 3 times will increase the heating temperature (the color of the diode will change):
Green color - low temperature (optimal for beginners and intermediate users)
Blue color - medium temperature (optimal for advanced users)
Red color - high temperature (optimal for advanced users)
If the device is turned on, pressing the button 2 times will preheat the liquid (the control diode will light up).